delete unusd workgroups

[Metco]

anyone got a macro to delete unused workgroups ?

[George Woyansky]

You can hide the workgroups you don't want and then Right-Click | Delete Hidden Workgroups in 23.0.X

[Metco]

right i didnt know we can do that...

[Metco]

how do you hide a workgroup?

[the_cnc_guy]

Do you want a macro to delete all workgroups which are empty ( no geometry ).
Easy to do. Just a few lines of code.

[JeremyS]

how do you hide a workgroup?

Close the eye

[Metco]

Do you want a macro to delete all workgroups which are empty ( no geometry ).
Easy to do. Just a few lines of code.

I want to delete all workgroups that non of the ops are using.

[the_cnc_guy]

Ahh ok,
A bit more code but still can do.
Check back tomorrow.

[Metco]

Ahh ok,
A bit more code but still can do.
Check back tomorrow.

cnc Guy if you got some time you think you can look the 3 jaw macro we talked about a while back?
you think you can make the 6 round chuck or 4 round chuck close in to stock within macro setup?

[the_cnc_guy]

Metco,
See "Purge Unused WG's" macro attached
Removes any WG's not being used by operations in the op list ( whether geometry exists or not )

cnc Guy if you got some time you think you can look the 3 jaw macro we talked about a while back?
you think you can make the 6 round chuck or 4 round chuck close in to stock within macro setup?

Ya, I did start this.
As I started laying out the basic framework, it started becoming a bigger and bigger project.


I do want to complete this, I just have a heavy workload right now. I will be taking some time off possibly next month so I see myself doing some evening tinkering on this.

[Metco]

Metco,
See "Purge Unused WG's" macro attached
Removes any WG's not being used by operations in the op list ( whether geometry exists or not )





Ya, I did start this.
As I started laying out the basic framework, it started becoming a bigger and bigger project.


I do want to complete this, I just have a heavy workload right now. I will be taking some time off possibly next month so I see myself doing some evening tinkering on this.

that works thank you very much