Transition Between Holes SET_PROC_DATA <parameter>, variable

[jake722]

MD_RETRACT_LEVEL and DRILL_CLEAR_PLANE both output the same integer value(0-3). Not sure what the difference is...

[jake722]

"MD_RETRACT_LEVEL" will set the radio buttons. Pretty sure it's in the same order as the dialog (0, 1, 2, 3 top to bottom).
The parameter name for the field itself is probably "CP1".

i will try the MD_RETRACT_LEVEL. I did not see your reply when i posted.

[jake722]

Okay so I figured out the parameter for both the check box and the value stored in the Absolute Z textbox through process of elimination using the Debug. I doubt anyone else will run into this but I figure I may as well answer my own question for reference.

The parameter for between hole types:
DRILL_CLEAR_PLANE
integer type:
R Level = 0
Part Clearance =1
Absolute Z = 2
Hole Feature = 3

Parameter in "Absolute Z" textbox:
CP1

image.png

SET example (*Note: you must reopen process to see changes):
SET_PROC_DATA 1, DRILL_CLEAR_PLANE, 2 !Set Transition to Absolute Z
SET_PROC_DATA 1, CP1, 1.2345 !Set Absolute Z value to 1.2345



GET example:
GET_PROC_DATA 1, DRILL_CLEAR_PLANE, <variable name>
GET_PROC_DATA 1, CP1, <variable name>

[DanielR]

"MD_RETRACT_LEVEL" will set the radio buttons. Pretty sure it's in the same order as the dialog (0, 1, 2, 3 top to bottom).
The parameter name for the field itself is probably "CP1".

[jake722]

I need to auto set the "Transition Between Holes" to "Absolute Z" and set the value to a specific number. I'm having trouble locating the Parameter that sets these. Does anyone know?
image.png