Anyone looking for a Job? $27 - $40hr Chattanooga,TN (relocation assist. possible)

[planes1353]

Maybe try switching from auto to manual and adding a larger number in the radius box. Might also try putting a bigger number in your CRC line box. I don't...

[planes1353]

I'd try putting something in the "Entry/Exit Arc" boxes in the bottom left corner....

[planes1353]

Can you post a screen shot of your OP settings?

[planes1353]

I'm looking for a machinist/programmer to program, setup, and run decently complex automotive die parts from start to finish. This is probably going to...

[planes1353]

The only way I know of is to use simulation and create a facet body. You can then use the profiler to extract geometry and measure it. Not perfect, but...